To erase the available data on the flash IC you need to first press the Read Button. This button is used to erase or format the currently available data on flash ic. If your IC is having 4 MB data then it takes around 3 minutes.Īfter that it shows the data available on this flash IC. Initially when you open the programmer software then on screen it shows blank data like FF FF FF FF etc.īut when we press Read Button then this software started to read Flash IC Data. After this information confirmation you need go for following buttons according your use case. So this button is used to show full information of flash IC like its Make, Memory and Device ID etc. If its reading flash IC then it will show you information of Flash IC. Because it indicates that your flash ic is connected properly or not. This is the first button which we should press after connecting this programmer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
June 2023
Categories |